top of page
TWO COLOUR CHOICES:
SATIN BLACK
VWR800001
SATIN SILVER
VWR800002
TWO SIZE CHOICES:
supplied as a left and right pair
SHORTER LENGTH
For the smaller cars - of Golf size and below.
Golf, Audi A3, TT, Leon, Octavia, Polo etc.
LONGER LENGTH
For the larger cars - bigger than Golf size.
Audi A4/A5/A6, Passat, Arteon, Superb
Each decal is made from high quality PVC vinyl, supplied with strong self-adhesive. Water and sun-proof.
FITTING.
Due to the length of each stripe, we advise fitment by an experienced graphics installer for best results. However, it's an easy DIY job if you want to approach fitment yourself.
Thoroughly clean and degrease the area of your bodywork. Ensure completely dry.
Spray a mist of water and soap onto the car, allowing the sticker to be adjusted into position. Peel off a short section of the backing sheet and carefully place the exposed adhesive surface onto the bodywork.
Locate your desired stripe position carefully. Ensure they're consistent on each side of the car. Ideally mark your line with masking tape.
Slowly peel off more short sections of the backing sheet, rubbing the stripe down with a soft cloth as you go along to ensure all adhesive has stuck and any liquid is squeezed out. Finally use a sharp knife to trim the door openings.
Note on fitting. As these are a generic 'One Size Fits All' single-piece decal, it's likely that some trimming will be required for certain models to achieve the perfect fitment. We recommend that you trim the smaller, front edge to size if you feel you want to shorten the stripe. Also, adjustments in length can be made carefully at the door shut lines if required.
bottom of page